Q: WHAT PARTS SHOULD BE TREATED?

A: Any part subject to friction, loss of lubricating film, heat damage, corrosion or abrasion. In addition enhanced appearance is possible for parts such as headers, brackets, and suspension pieces.

Q: HOW MUCH POWER WILL I GAIN?

A: This will depend upon many factors that will vary from application to application. Testing has shown significant power increases on a dyno. In addition certain changes can be made in such areas as tolerances, timing, jetting and the lubricants used, that will increase torque and H.P. and are only possible through the use of coatings. Horsepower gains of up to 40h.p. have been measured in independent dyno testing.

Q: HOW LONG WILL THE COATINGS LAST?

A: Depending on the coating, part life increases from two (2) to ten (10) times what is normal can be seen. In addition coatings such as CERMAKROME can provide virtual lifetime protection against rust. The dry film lubricants may burnish until they are no longer visible, however, the active materials are bonded into the pores of the part and continue to provideprotection.

Q: WILL I SEE A TEMPERATURE CHANGE?

A: Parts will run cooler. Engine oil and water temperatures have shown a reduction. On headers the radiated heat will be substantially reduced leading to lower underhood temperatures and less heat absorption by nearby parts andsurfaces

Q: How do I polish the ceramic chrome?

A: With mothers aluminum polish you can keep them very shiny

About Us  |  Terms Of Service  |  Privacy Policy